M39 tap drill size
The tap drill for an M39 × 4 metric coarse thread is 35 mm (1.3780 in). It leaves about 77 % thread, the normal range for steel.
Choose a drill
Each option redraws the section above with the thread it would leave.
M39 thread data
- Thread
- M39 × 4 coarse
- Pitch
- 4 mm 6.3 TPI
- Tap drill
- 35 mm
- In inches
- 1.3780"
- Thread engagement
- 77 %
- Major diameter
- 39 mm
Clearance holes for M39
ISO 273 clearance holes. The dashed circle is the M39 bolt at the same scale.
How much thread you need
Thread percentage to aim for by material.
Bars run from 50 % to 90 % thread. Typical shop practice for cut taps. Harder, tougher materials take less thread to save the tap; soft materials need more engagement to hold.
How the percentage is worked out
- D
- 39 mm, major diameter
- drill
- 35 mm
- P
- 4 mm pitch
Why not 100 %?
Going from 75 % to 100 % thread adds only about 5 % strength but roughly triples the torque needed to turn the tap. That is why the standard drill leaves 70–80 %.
For cut taps the quick rule is drill = major diameter − pitch. Form (roll) taps displace metal instead of cutting it and need a larger hole, roughly D − 0.5 P; check the tap maker's chart.
Other metric coarse threads
Common questions
What size drill for an M39 × 4 tap?
Use a 35 mm drill. It leaves about 77 % thread engagement.
What is 35 mm in inches?
35 mm is 1.3780 inch.
What size clearance hole for M39?
ISO 273 gives 40 mm for a close fit, 42 mm normal and 45 mm loose.